Reboot 135Amp MIG Welder, 110V Flux Core Welder Flux MIG IGBT Inverter Welder US

  

MIG Welder 135A Flux Core Wire Digital IGBT Gasless Welding Machine No Gas 110V. About the MIG135E Welding Machine. Reboot welders adopt the latest PWM technology and IGBT power module, which can change work frequency to medium to replace the traditional transistor transformer with the medium frequency transformer.

All of our welders are very friendly to beginners in welding and can quickly get started. Power supply (V): 1 phase, 110 V ± 15%.

Open circuit voltage (V): 58. Nominal input current (A): 13.4.

Setting range of the output current (A): 45 - 130A. Output voltage (V): 15.5 - 18.5. Duty cycle: 20% at 90A. Power factor:> 0.7. We will take each and every action to prevent you from bearing any loss as we value our customer's investment and trust more than anything else.

Power indicator: Power on, this light blinks. Fault light: When the welding load is overloaded and the output current of the machine is too large, this light will be on. This situation is normal and the machine can be restored; when there is damage inside the machine, this light will be on. In this case, the machine is abnormal and requires maintenance. Adjust the value knob: Turn on the power, When the value reaches 1, the power indicator stops flashing and will stay on. Clockwise rotate to enlarge the current, and anti-clockwise rotate to reduce the current. Positive Terminal: Connect the ground wire. No wire feed wheel is required and the wire can be fed directly through the installation of the welding wire, which is very convenient and time-saving. Support 0.8mm and 0.9mm welding wire, we are equipped with 0.8mm welding wire, so you can use it when you receive the goods (Note: 0.9mm welding wire not equipped). This machine supports the use of gas-free welding, which is very convenient, relieves the gas cylinders and does not have to worry about the inconvenience of outside welding. Can be welded to a thickness greater than or equal to 0.5mm, suitable for welding carbon steel and low carbon steel. The fan has a sleep function and may not spin after turning it on, which is normal.

The machine is equipped with a heat dissipation and overheating protection function which, if the machine is running too hard, activates the rear fan to dissipate the heat from the internal parts of the machine. A smarter design will make your machine last longer. We have a solid service system.

We provide 3 years product quality service, 24 hour online service to answer your question. Our factory's production process has been checked layer by layer to ensure that each machine is performing well for you.

How to install the belt. Take the parts of the belt and prepare to install the belt on the welder. Thread the belt on both sides of the machine. Adjust the belt length to your needs. The weight of the welding machine is only 5.4 kg, small. It is very suitable for carrying on the shoulder to continue the welding process. The belt is soft and adjusts to the angle according to the shoulder and the shoulder will not hurt even after a long time. Test the existing packaging is reasonable and reliable, can meet the transportation requirements.

After repeated 30 tests and improvements, the existing packaging is finally determined.